GL srew joint system: assembly

[Translate to english:] Montage leicht gemacht – wie Sie schnell ans Ziel kommen.

A GL-threaded neck
B Sealing ring
C Tapered ring
D V-ring
E Screw cap with internal cone
F Tubing or tube
G (only for screw joints for tubing dia. under 3 mm)

Assembly:

Assembly:
1. Push the screw cap on the tubing/tube
2. Push V-ring, tapered ring and then sealing ring on the tubing/tube
3. Tighten the screw cap on the GL-threaded neck – ready

How to make your order:

A screw joint always consists of two elements:

Fitting (straight, elbow, T-shape or a GL thread of a glass device)
Laboratory screw joint as connection between fitting and tubing/tube

Example 1:

If you want to connect three tubes/ tubings with O.D. 6 mm
you will need:

A 1 piece of GL tube fitting T GL 14 – Cat. No. D 540-14
B 3 pieces of HT laboratory screw joints GL 14 for tubing O.D. 6 mm,
Cat. No. D 628-74

Example 2:

If you want to connect tubing with different O.D. (2 mm and 6 mm) in an angle of 90°, you will need:

A 1 piece of GL tube fitting elbow GL 14 – Cat. No. D 539-14
B 1 piece of HT laboratory screw joints GL 14 for tubing O.D. 6 mm,
Cat. No. D 628-74
C 1 piece of HT laboratory screw joints GL 14 for tubing O.D. 2 mm,
Cat. No. D 628-34

URL of this page: http://www.bola.de/nc/en/technical-information/screw-joints/gl-srew-joint-system-assembly/kapitel/20/kategorie/50/num/D__681_00/y/117/x/D__681_00/ext/detail.html